Joined in 2023 
82 
63 About this deal
There are all kinds of aerials available on the market and some which are specific to certain frequencies. A wideband aerial is a popular choice, although there are other aerials available. A qualified aerial installer with local knowledge will be able to advise further.
Peatman, W.C.B.; Daniel, E. S. (2009). "Introduction to the Special Section on the IEEE Compound Semiconductor Integrated Circuit Symposium (CSICS 2008)". IEEE Journal of Solid-State Circuits. 44 (10): 2627–2628. Bibcode: 2009IJSSC..44.2627P. doi: 10.1109/JSSC.2009.2029709.
Rega io
The most common FM radio aerial on a portable radio is a telescopic one. To get the best reception extend the aerial fully and move the aerial and radio around until you get the best reception. If using a hi-fi with a wire aerial, again extend as much as possible to get the best signal. The telescopic aerial fitted to stereo portables is a compromise and the radio will often only give really good results if connected to an external aerial. If that’s not possible, switch to mono as it will usually sound better. Some sets do this automatically. This is not a product that encourages analysis of the hi-fi system or the recording being played. It is more than transparent enough to perform that role but prefers to put the spotlight firmly on the music. That’s the way we like it. Does the ITx live up to our fond memory of the original from the late 90s? Yes, it absolutely does. As soon as any connection within the circuit gets longer than perhaps 1% of the wavelength of the highest specified frequency (e.g., at 100MHz the wavelength is 3m, so the critical connection length is approx. 3cm) design properties radically change. For example, a specified length and width of a PCB trace can be used as a selective or impedance-matching entity.
The successor to our multiple-Award winning Rega Elex-R, one of our favourite amplifiers of the last decade, is thankfully far from a disappointing sequel. Depending on the transmitter you are using, your aerial elements will need to be mounted flat (horizontal) or on its side (vertical).A qualified aerial installer with local knowledge will be able to advise further. And finally, here is a variety of new and used products — and while they quite possibly will break the bank, acquiring one of these should mean you need never buy a power amp again!Although active and powered monitors now dominate the studio market, their passive cousins can still do the job needed, they’re still being made — we’ve reviewed a few new passive nearfield monitors in the past couple of years — and they still attract their fair share of users. Along with sales of new monitors, there are also countless pairs of passive speakers in use, be they venerable hi-fi KEFs, Missions or B&Ws, battered old NS-10s and Auratones, or more expensive older studio monitors that continue to do sterling service day in and day out. Advice on choosing and using such speakers is accessible enough, but what about the amps that drive them? Whether you’re buying a new set of speakers, you’ve just landed a bargain set of NS-10s, or your current amp has passed to the great electronics graveyard in the sky, just what do you need to know when choosing a new amp? Obstructions between the aerial and transmitter can cause problems. Trees are the most common obstructions. They can affect the signal. This can be greater at different times of the year (when there are more leaves), when wet or in high winds.
A common solution to help stabilise the output devices is to include some emitter resistors, typically one ohm or so. Calculating the values of the circuit's resistors and capacitors is done based on the components employed and the intended use of the amp. The Lavardin ITx is one of the most uncluttered and self-effacing amplifiers we’ve ever heard. Its presentation isn’t warm or rich in the manner of some valve designs, but it is incredibly sweet sounding, in all the best ways. This is also a fast and fluid performance, one that’s immensely precise without sounding clinical in any way. It boasts trademark Marantz styling and is a solidly built, nicely finished integrated amplifier with traditional hi-fi appeal. If you are experiencing pixellation or picture break up, it may be that your signal is too strong as this often presents itself similarly to a weak signal. This is likely to happen if you live close to a transmitter. From 19th June, we put out extra messaging on the version of BBC One that our SD-only satellite viewers will see, reminding them of the need to upgrade, please see our FAQ.
Radio Help Guides
If you suffer from reception problems in the evening, this suggests that the signal getting to your television is not quite strong enough. Changes in the weather, temperature or atmospheric pressure can cause an already poor signal to break up or be lost.
Great Deal 
New Comment