About this deal
Early versions of the TS 254 actually had problems with build quality. The thread on the height adjustment mechanism would get worn out and so you couldn’t lower or raise the blade anymore. Of course this is a significant problem.
However it, is not without problems either. The standard angles cannot be corrected, so if your miter slot is not exactly at 90 degrees, there is no official way to correct for this. Personally I found a basic DIY fix with duct tape on my TS 254 M, which has the same miter gauge. But it is a clear limitation. Metabo sliding table If you get the DWE7492 instead, I would suggest immediately upgrading to an aftermarket miter gauge (there are many good ones to choose from), or making a table saw sled yourself. One advantage of the DeWalt is that it has a standard size miter slot, so you can fit in almost any aftermarket gauge. In connection with the OFL1.0 / OFL2.0 and the Bosch GOF1250CE/LCE we recommend the additional router extension T-CE-88 to compensate the loss auszugof height (handle of the router hits the housing of the GTS10)Loading...